Home > Sterilizers > RapidHeat Sterilizers >

RapidHeat RH-Pro11 High-Velocity Hot Air Sterilizer

New RH-Pro11 High-Velocity Hot Air Sterilizers

MADE IN THE USA

Availability: In Stock
Product Code: NRH-PRO11

Description

Technical Specs

Literature

New RapidHeat RH-Pro11 High-Velocity Hot Air Sterilizer by CPAC available in 110-120V and 220-240V

The perfect replacement for the now discontinued Dentronix Sterilizer. The RH-Pro11 even accommodates Dentronix plier racks!
Read RapidHeat Sterilizers: The perfect replacement for the now discontinued Dentronix sterilizers

WARRANTY: 3 year parts & labor
Chamber air circulates at over 200 times per minute! Watch how it works in Video tab.

A proven advancement in “RapidCycle” sterilization, the RH-Pro11 sterilizer will raise your level of sterilization efficiency. Using Cutting-Edge HVHA (High-Velocity Hot Air) technology, the RH-Pro11 provides the fastest instrument turnaround of any FDA-Cleared sterilization technology. No steam or water means no lengthy drying cycle with longer instrument life free of corrosion. View How to Wrap and Tape Cassettes for RapidHeat Sterilizers

For Healthcare, the RH-Pro11 can Eliminate Immediate-Use Steam Sterilization, shortened cycles, work-arounds, and Joint Commission scrutiny!

The RapidHeat Sterilizer Advantage:

FDA-Cleared 6 Minute Cycles (Unwrapped)
FDA-Cleared 12 Minute Cycles (Wrapped)
Large Table-Top Capacity (2295 Cubic Inches)
Uses 85% Less Energy Than Steam
Non-Corrosive Sterilizer Environment
Full 3-Year Warranty
Waterless Sterilization with No Chemicals
Greater Capacity -- Four Large Trays
Handles Small and Large Cassettes
Available in 2 sizes:
- RH-Pro9 - 3 trays / chamber: 9.5”W x 15.6”D x 7.85”H choose 110V-120V or 220V-240V
- RH-Pro11 - 4 trays / chamber: 11”W x 17.75”D x 11.75”H choose 110V-120V or 220V-240V

Compare RapidHeat vs. Steam Sterilization

Sterilizer Feature	RapidHeat	Steam
Start to Finished Sterilization Cycle	12-20 minutes	61-116 minutes
Sterilizer Operation	Simple	Complex
Water Requirements	None	Distilled Water
FDA 510(k) Cleared	Yes	Yes
Cycle Documentation	Yes	Yes
Instrument Drying Cycle	None	FDA Required
Potential for Instrument Corrosion	None	High
Energy Use (kWh/cycle)	$0.11/cycle	$0.74/cycle
Maintenance and Repair Cost	$0.80/cycle	$6.00/cycle

Notes:
Start to finish cycle represents the time range for sterilizing unwrapped, pouched and wrapped (cassette/tray) instruments from cold start to finish (includes dry cycle for steam).
Sterilizer Operation reflects the level of sterilizer preparation and management for instrument processing.
Potential for instrument Corrosion is absent in the dry environment pf a RapidHeat sterilizer and high for instruments in a steam environment.
Energy Use represents kilowatts of power used per hour when operating a sterilizer cycle. This study was conducted by the Rochester Institute of Technology comparing RapidHeat to 2 popular tabletop steam sterilizers. Maintenance and Repair Cost is based on actual reported costs and estimated over useful life.

Features

Q. Can I use the same pouches for this sterilizer I use with my autoclave?
A. No, because RapidHeat sterilizers run up to 375 degrees; and most pouches made for steam sterilization cannot withstand that heat.

Q. We were of the understanding that we could put instruments in wet. Can you confirm that?
A. All instruments must by DRY when put into rapidheat sterilizers. Any liquid will produce steam inside the chamber. View How to Prepare Instruments for RapidHeat Sterilization for detailed instructions and tips from the manufacturer.

Q: Can I continue to use our old Dentronix plier racks in the Rh-Pro?
A: Yes – you can! See the IFU here.